asterisk

Using the Linksys SPA400 with Asterisk

Original article can be found here: https://voxilla.com/2006/11/08/using-the-linksys-spa400-with-asterisk/

For small- and medium-sized businesses, going all-VoIP is not an easy decision.

Fortunately, the switch-over, which can result in substantial savings and add bold new capabilities to tired old office phone systems, can be done in baby-steps: Purchase an Internet Protocol (IP) based phone system, but keep the PSTN lines, for now.

SIP Anveo Direct with SMS Send and Receive

Original Articel can be found here: http://nerdvittles.com/?p=5680

add textsupport=yes to inbound trunk conf in asterisk

 

How to configure Asterisk/FreePBX for CounterPath's Bria SoftPhone for Android/iOS or PC

This article is based on tehe original which can be found here: http://www.voip-info.org/wiki/view/Asterisk+Phone+Bria

 

Bria is the newest softphone application from CounterPath, allowing users to enjoy multimedia communications in a dynamic way.

How to setup Asterisk/FreePBX behind NAT

This HOWTO assumes that your FreePBX system is sitting behind a NATed firewall with no direct connection to the outside world and it is NOT in the DMZ zone. If you have your system facing outside, or have used Mapped IP addresses or other techniques, then it is assumed that you have adequate knowledge to interpret these instructions and also assure that you have properly secured your installation.

The three key considerations in setting up remote extensions are:

HOWTO Setup A Remote SIP Extension

This HOWTO assumes that your FreePBX system is sitting behind a NATed firewall with no direct connection to the outside world and it is NOT in the DMZ zone. If you are relying on this article to set-up your system, DO NOT place your system on a public IP address or a DMZ zone. This article does not address the potential security implications involved in such a setup.

The four key considerations in setting up remote extensions are:

Subscribe to RSS - asterisk