procurve

HP Procurve hidden commands

 
 

This will dump all infog from a Procuve switch:

telnet 10.10.0.18 -f C:\28218.txt enable show tech all

Instructions:

Cisco Catalyst 3750 to HP Procurve Trunk Configuration

Cisco Catalyst 3750 IOS Commands

 

interface GigabitEthernet 1/0/8

description Link 1

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1-100

switchport mode trunk

speed 1000

duplex full

no cdp enable

channel=group 10 mode active

 

interface GigabitEthernet 1/0/9

description Link 2

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1-100

HP Procurve and Cisco Catalyst Interoperability Notes

HP Procurve and Cisco Catalyst Interoperability Notes

These are basic notes about interoperabilty on Cisco and HP Switches

See attached:

 

QOS 802.1p on Cisco 3750 and HP Procurve Switches

Cisco 3750 QOS 802.1p testing Notes:

 

 

HP Procurve QOS configuration

 

HP Procurve Configuration Quick Start Guide

1. Basic Information

The HP Procurve Switch 2824 is a Layer-2-Switch. It means that the switch does not only switch network packets at the MAC level. The switch is also able to route ip network packets.
For a full description of the capabilities please read the product description. This short guide describes only the basic handling and configuration of the switch.

HP Procurve Firmware update

To update the IOS on the HP's ProCurve switches you first need to configure an access port so it can communicate to the TFTP Server.ProCurve Switch 3500yl-48G> enableProCurve Switch 3500yl-48G# configure terminalProCurve Switch 3500yl-48G(config)# vlan 1ProCurve Switch 3500yl-48G(vlan-1)# ip address 10.10.10.1/24ProCurve Switch 3500yl-48G(vlan-1)# exitNext, you will need to configure the network adapter on your PC or laptop and give it an address that's on the same network as the switch.

Subscribe to RSS - procurve