hp

Cisco Catalyst 3750 to HP Procurve Trunk Configuration

Cisco Catalyst 3750 IOS Commands

 

interface GigabitEthernet 1/0/8

description Link 1

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1-100

switchport mode trunk

speed 1000

duplex full

no cdp enable

channel=group 10 mode active

 

interface GigabitEthernet 1/0/9

description Link 2

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1-100

HP Procurve Firmware update

To update the IOS on the HP's ProCurve switches you first need to configure an access port so it can communicate to the TFTP Server.ProCurve Switch 3500yl-48G> enableProCurve Switch 3500yl-48G# configure terminalProCurve Switch 3500yl-48G(config)# vlan 1ProCurve Switch 3500yl-48G(vlan-1)# ip address 10.10.10.1/24ProCurve Switch 3500yl-48G(vlan-1)# exitNext, you will need to configure the network adapter on your PC or laptop and give it an address that's on the same network as the switch.

HP Procurve and Cisco 3750 Configuration Notes

In my original configuration, I set up a trunk of 3 vlans between my cisco 3750 and HP procurve switches.Vlan 1, 7 and 9  have been working fine.  I want to extend it to include vlan 13, so I made the following changes to allow vlan 13 to go through the trunk.Cisco : - switchport trunk allowed vlan 1,7,9,13 (added 13)HP: -  vlan 13  tagged 24=============================================interface GigabitEthernet1/0/24 switchport trunk encapsulation dot1q switchpor

Subscribe to RSS - hp