cisco

Assigning Static-Access Ports to a VLAN

Reset Cisco Catalyst 2950 Switch

Original Article: https://supportforums.cisco.com/t5/lan-switching-and-routing/2950-24-username-password-recovery/td-p/1774008

Step-by-Step Procedure
Follow the password recovery procedure below.

Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.

Use the following terminal settings:

Bits per second (baud): 9600


Data bits: 8


Parity: None

Cisco ATA 186 Default Config Procedure

  •  Power up the ATA
  •  Make sure the ATA is *NOT* plugged into the network.
  •  Plug an analogue phone into voice port one.
  •  Lift the handset, and press the button on top of the ATA
  •  You will be greeted by the American female darlek.
  •  Dial 322873738#*

 

Reseting a Cisco Catalyst Express 500 using a Windows 7 PC/Laptop

 

Manual Set the IP address of your P to 10.0.0.2 initially with a gateway to 10.0.0.1

 

 

After the reset set your PC to 169.254.0.2 and a Gatewayof 169.254.0.1

Cisco IP Phone 7945 with SIP Configuration

This article is based on the original that can be found here: http://row5.net/post/18655850352/cisco-ip-phone-7945-with-sip-configuration

Asterisk phone cisco 79x1 xml configuration files for SIP latest 79x1 Series

Windows NPS Radius Authentication of Cisco Prime Infrastructure

Cisco POE Power over Ethernet Calculator

Extreme XOS and Cisco IOS Command Comparison and Equivilents

Extreme – Create 2 VLANs and basic configuration

create vlan data
configure vlan data tag 2
configure vlan data ipaddress 10.0.2.1/24
create vlan voice
configure vlan voice tag 3
configure vlan voice ipaddress 10.0.3.1/24
enable ipforwarding

Cisco – Create 2 VLAN interfaces and basic configuration

UCS Nexus 1000V VMware ESXi 5.1 and Windows 2008 R2 with VMXNET3 paravirtual adapter

Based on VMware Knowledge base articles 2020567 and 2039495

 

Operating System Specific Adapter Policies

Pages

Subscribe to RSS - cisco