vlan

Assigning Static-Access Ports to a VLAN

Adding VLANs to Cisco Nexus 1000v

This is the simple process to follow when adding a VLAN and subsequent VMware VM access port group and to a Cisco Nexus 1000v switch.

The annoyance is that you can monitor the configuration of your Nexus 1000v through VMware Virtual Center; however you can't configure it.  All Nexus 1000v configuration must be done at the command line.

In this post I present to you the configuration commands I use when adding an additional VLAN to a Nexus 1000v switch.

Netscreen VLAN Configuration

Here is a basic configration on how to set the zones and interfaces up, you would still need policies and management and suchset vrouter trust-vr sharableunset vrouter "trust-vr" auto-route-exportset zone id 101 "Trust 1"set zone id 102 "Trust 2"set zone id 103 "Trust 3"set interface "ethernet1" zone "Untrust"set interface "ethernet2" zone "Trust 1"set interface "ethernet3" zone "Trust 2"set interface "ethernet4" zone "Trust 3"set interface ethernet1 ip 64.0.24.1/30set interface ethernet1 routeset interface ethernet1 gateway 64.0.24.2set interface ethernet2 ip 90.1.1.1/24set interface ether

VLAN Configuration on Virtual Switch, Physical Switch, and Virtual Machines

 

Purpose

This article describes the various VLAN tagging methods used with ESX/ESXi.
 
Virtual LAN (VLAN) implementation is recommended in ESX/ESXi networking environments because:
  • It integrates ESX/ESXi into a pre-existing network
  • It secures network traffic

VMware ESX, NIC Teaming, and VLAN Trunking with HP ProCurve

VMware ESX, NIC Teaming, and VLAN Trunking with HP ProCurve

In an earlier article about VMware ESX, NIC teaming, and VLAN trunking, I described what the configuration should look like if one were using these features with Cisco switch hardware. It’s been a quite popular post, one I will probably need to update soon.

Subscribe to RSS - vlan