catalyst

Assigning Static-Access Ports to a VLAN

Reset Cisco Catalyst 2950 Switch

Original Article: https://supportforums.cisco.com/t5/lan-switching-and-routing/2950-24-username-password-recovery/td-p/1774008

Step-by-Step Procedure
Follow the password recovery procedure below.

Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.

Use the following terminal settings:

Bits per second (baud): 9600


Data bits: 8


Parity: None

Reseting a Cisco Catalyst Express 500 using a Windows 7 PC/Laptop

 

Manual Set the IP address of your P to 10.0.0.2 initially with a gateway to 10.0.0.1

 

 

After the reset set your PC to 169.254.0.2 and a Gatewayof 169.254.0.1

Cisco Catalyst 3750 to HP Procurve Trunk Configuration

Cisco Catalyst 3750 IOS Commands

 

interface GigabitEthernet 1/0/8

description Link 1

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1-100

switchport mode trunk

speed 1000

duplex full

no cdp enable

channel=group 10 mode active

 

interface GigabitEthernet 1/0/9

description Link 2

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1-100

Upgrade Cisco 2960G Switch from IOS CLI

  1. Enter the Cisco Catalyst 2960G via Telnet or Serial Console
  2. Enter the “enable” command at the command prompt, and tap the “Enter” key. Enter the Privileged Exec password when requested, and then tap the “Enter” key.

HP Procurve and Cisco Catalyst Interoperability Notes

HP Procurve and Cisco Catalyst Interoperability Notes

These are basic notes about interoperabilty on Cisco and HP Switches

See attached:

 

Subscribe to RSS - catalyst