configure

Manually configuring a Polycom SoundPoint IP 320, 321, 330, 331, 450, 550, 560, 650, 670 and SoundStation IP 6000, 7000

Note 1: This guide has been tested with firmware version 3.3.1 and Bootrom 4.3.0. Be aware that different firmware revisions may have different web interface formats and functionality.

Note 2: This FAQ is based on a new phone OR one that has been reset to factory defaults. If in doubt, reset the phone to Factory Defaults.

The preferred method to configure a Polycom Phone is via Provisioning. You can however follow this guide to manually configure your phone.

Configuring the Phone to Register with 3CX Phone System

libtoolT errors in autoconf(./configure) in tomcat connector source compile on CentOS 6 64bit

Normal run of libtool, produces no other warnings until the end of the 
master configure script.
At which point out pops:
  config.status: executing libtool commands
  /bin/rm: cannot remove `libtoolT': No such file or directory

This is resolved by placing:
  $RM -f "$cfgfile"

at line 680 of /usr/share/aclocal/libtool.m4

 

NOTE: If you already started your ./configure (autoconf) run you will need to locate the localized libtool.m4 commands in configure.status

Subscribe to RSS - configure